Directed Video DV1600 Guide d'installation télécharger pdf (Page 10)

10

© 2002 Directed Electronics, Inc.

REMOTE CONTROL BATTERY

■

Battery Installation

■

Press on the panel at the rear of the

remote control and slide the battery

cover open.

■

Insert the batteries while observing

the correct (+) and (-) polarities.

■

Slide the battery cover into place on

the back of the remote control.

■

Service life of batteries - The batteries nor-

mally last for about six months, although

this depends on how often the remote

control is used.

■

If the remote control until fails to work,

even when if is operated near the player,

replace the batteries.

■

Use size AAA batteries.

■

Do not drop, step on, or otherwise impact

the remote control unit.

■

Do not mix old and new batteries.

■

If the remote control is not going to be

used for a long time, remove the batteries.

REMOTE CONTROL OPERATION RANGE

This unit is supplied with an external remote sen-

sor which allows you to access all features by

remote control when the DVD unit is mounted in

a location where the DVD is out of the line of

sight.

The remote control should not be used from

more than about 23 feet (7m) from the remote

control sensor and within about 60 degrees of

the front of the payer. The operating distance

may vary according to the brightness of the

vehicle interior.

PRIOR TO USE

■

The player output signal must be adjusted

to match the monitor system type. Press

the SYSTEM (22) button to change the sys-

tem output signal type as shown.

■

During playback, the TV volume may be at

a lower level then other source units. If

this is the case, adjust the volume to the

desired level.

■

Select the appropriate screen type from

the setup menu according to your monitor.

■

Connect the DVD player according to the

instructions in the Installation section of

this guide.

■

If the DVD player is connected to the mon-

itor through a VCR, the picture may not be

played back normally. It is strongly recom-

mended not connecting the DVD player

through a VCR.

■

The on-screen menu language of your play-

er has been factory preset to English. If

you would like to change the menu lan-

guage, please refer to the Setup Menu sec-

tion of this guide.

■

Check the following before using the DVD

player:

■

The monitor and audio equipment are

properly connected to the player.

■

The power for the monitor and audio

equipment is turned on.

■

The input setting for the monitor and

audio equipment is properly selected.

Remote Operation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire