Directed Video DV2600 Instructions d'exploitation télécharger pdf (Page 12)

12- ENG

A00034

4. Remove the high-pressure nozzle

from the spray wand. Remove any

obstructions with the nozzle

cleaning tool provided and

backflush with clean water.

5. Direct water supply into spray

wand to backflush loosened

particles for 30 seconds.

6. Reassemble the nozzle to the

wand.

7. Reconnect spray wand to gun and

turn on water supply.

8. Start pressure washer and place

spray wand into high pressure

setting to test.

HOW TO CLEAN THE WATER

INLET FILTER

This screen filter should be checked

periodically and cleaned if necessary.

1. Remove filter by

grasping end and

removing it from

water inlet of pump

as shown.

2. Clean filter by

flushing it with water on both

sides.

3. Re-insert filter into water inlet of

pump. NOTE: Cone side faces

out.

NOTE: Do not operate pressure

washer without filter properly installed.

MAINTENANCE

When performing

maintenance, you

may be exposed to hot surfaces,

water pressure, or moving parts that

can cause serious injury or death!

Before performing any maintenance

or repair, disconnect spark plug

wire, let engine cool and release all

water pressure. The engine contains

flammable fuel. DO NOT

smoke or

work near open flames while

performing maintenance.

To ensure efficient operation and

longer life of your pressure washer, a

routine maintenance schedule should

be prepared and followed. If the

pressure washer is used in unusual

conditions, such as high-temperatures

or dusty conditions, more frequent

maintenance checks will be required.

ENGINE

Consult the Engine Owners Manual for

the manufacturer's recommendations

for any and all maintenance. NOTE:

The frame is equipped with an oil drain

hole to help make changing the engine

oil easier.

PUMP

The pump on this unit is maintenance

free and requires no oil, if there is a

problem with the pump contact an

Authorized Service Center.

NOZZLE CLEANING

If the nozzle becomes clogged with

foreign materials, such as dirt,

excessive pressure may develop. If

the nozzle becomes partially clogged

or restricted, the pump pressure will

pulsate. Clean the nozzle immediately

using the nozzle kit supplied and the

following instructions:

1. Shut off the pressure washer and

turn off the water supply.

2. Pull trigger on gun handle to

relieve any water pressure.

3. Disconnect the spray wand from

the gun.

Filter Screen

HOW TO REMOVE THE

WHEELS

1. Using a 1/8" hex

head wrench

loosen set screw

in hub collar.

2. Slide hub collar

from axle and remove the tire.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire